Printhead - 3D Systems ProJet 6000 User Manual

Printhead

Control/Indicator Function
Position Current X Position and Y Position of the beam in mirror counts .
Power Requested laser power .
Printhead Switch the laser On or Off .
Shutter
Open and close the shutter .
Spot Set the IPM to the small or large spot focus position .
Res .
System Mode, select High or Low .
Motion Actions Select
Profiling Select
Move to Rest Moves the beam to the rest position .
Set Rest Set the rest position for the beam .
Calibrate Mirrors Presently not enabled .
When Motion Actions is selected, the panel displays the functions outlined in red .
Control/Indicator Function
X Specifies the absolute coordinate for X in mirror counts.
Y Specifies the absolute coordinate for Y in mirror counts.
Move Print Spot Move beam to the position specified by
Defines the distance increment when moving the beam with the arrow buttons. To move the beam faster,
Distance
use a larger value. For fine movement, use a smaller value.
Arrow keys move the beam in the specified direction.
3D Systems, Inc.
Motion Actions mode . See table below for more information .
Beam Profiling mode . See table below for more information .
X and Y .
39