3D Systems ProX DMP 300 User Manual page 74

Parts:
• 1x kit "Disposable Process Filter" (part number : 151605), including :
• 1x filter vessel in closed state, with closing set mounted on it: 2x clamps (1), 2x cover lids (2), 2x centering rings with
stand-off (3)
• 2x standard centering rings (4)
4
2
• ADR stickers (European Agreement concerning the International Carriage of Dangerous Goods by Road) . The
sticker must be applied on the filter vessel before shipping it to waste management.
- ADR 4.2: apply when filter is full with Ti fumes
- ADR 9: apply when filter is full with Ni or Co containing fumes
• 2x cover lids that have been kept aside during the used process filter installation. They will be used to close the filter
during the replacement . The procedure will indicate to store it for later use .
Caution: the clean filter vessel is filled with argon to avoid water condensation during transportation.
WARNING: OPEN NEW FILTER VESSEL ONLY AT THE MOMENT OF CONNECTION TO MACHINE . KEEP OPEN
TIME TO ABSOLUTE MINIMUM .
WARNING: ALWAYS LEAVE DIRTY FILTER VESSELS FIRMLY CLOSED AND MARK CLEARLY THAT IT CONTAINS
EX AND FLAMMABLE SOLIDS AND/OR ENVIRONMENTALLY HAZARDOUS SUBSTANCES USING THE PROVIDED
ADR LABELS . STORE DIRTY FILTER VESSELS IN A SAFE LOCATION WITHOUT THE RISK OF BEING DAMAGED
OR OPENED BY UNAUTHORIZED PEOPLE .
WARNING: DO NOT START THE LENS CLEANER BLOWER WHILE THE PROCESS FILTER IS NOT CONNECTED TO
THE PRINTER .
Tools:
• Permanent marker
• 10mm wrench
• 5mm Allen wrench
3D SYSTEMS, INC.
1
70
3
PN:80-D27 Rev.B