3D Systems ProX DMP 300 User Manual page 44

Step 1 : Initialization
For each new job preparation, the printer must be initialized at first. The initialization step is performed automatically:
1 . Click on the automatic cycle launch button (1) .
2 . When automatic cycle completed, click on
Step 2 : Unloading plate
NOTE: If there is no sintering plate to unload, the step 2
is not to be performed. In this case, confirm the pop-up
message to go directly to the next step .
This step includes both manual and automatic actions, divided in 4 sections :
A . Plate cleaning (including the recycling and unloading plate cycles)
B . Carriage cleaning and unloading plate
C . Gas diffuser cleaning
D . Chamber cleaning
During the step 2:
1 . Perform the actions (1) by using the available
commands (2) and the external controls panel .
Consult the section "Unloading a plate" on page
64 for details .
2 . Click on the automatic cycle launch button (3) when
requested .
3 . When the 4 sections are complet, the next step will
Next
be enabled . Click on
3D SYSTEMS, INC.
Next (2) to go to the next step .
(4) .
2
40
1
2
1
3
4
PN:80-D27 Rev.B