3D Systems ProX DMP 300 User Manual page 46

Step 5 : Zero sintering
After installating a new sintering plate, the printer has to perform a zero sintering . Consult the section "Zero sintering
search" on page 59 for details .
This step is performed automatically . No manual
action is required, except the start cycle:
1 . Click on the automatic cycle launch button (1) .
2 . During the automatic cycle, the user is prompted to indicate if a standard 25mm plate is
used (2):
• If yes, click "Yes" . Then the automatic actions will continue . When completed, click on
Next (4) to go to the next step .
• If a different 25mm plate is used, then select "No", and proceed to the point 3 .
3 . Position the sintering plate through the new window (3) (with the or
entering a setpoint), then confirm by clicking on
4 . When the automatic cycle is completed, click on
Step 6 : Powder bed
This step will allow to :
• Smooth the powder from the feeding piston .
• Create the powder bed : the first powder layer
must be deposited on the sintering plate .
• Clean the roller .
1 . Select on the cycles list the desired sequence (1):
Powdersmoothing.S to smooth the powder from
the feeding piston, GapFilling.S to supply powder
between the two pistons, PowderBed.S to create
the powder bed on the sintering piston, or Roller.S
to clean the roller . Consult the section "Creating
the powder bed" on page 60 for details .
2 . Option : change the Iteration number
Powder raising
parameters (2) .
3 . Click on the start sequence button (3) to launch
the desired sequence .
4 . When the desired sequences completed, click on
Next (4) to go to the next step .
3D SYSTEMS, INC.
.
Next
(4) to go to the next step .
and/or
42
1
button, or by
3
1
2
PN:80-D27 Rev.B
4
2
3
4