3D Systems ProX DMP 300 User Manual page 52

When validate, the remaining time before the start will be displayed:
The manufacturing will start at the end of the specified time and if the current oxygen value is under the "Oxygen limit
value to produce" setting . If not, the start of the manufacturing will be aborted and a windows error will appear :
Manufacturing launch warnings
After clicking on the button, if there are some warnings, the "Manufacturing
launch warnings" message will appear:
This is a warning information to indicate:
• Lens cleaner filter timer compared to the recommended interval replacement,
• Current oxygen value compared to the "Oxygen limit value to produce" setting,
• Scanner head sensor state .
• Base plate clamping state .
Fix them before continuing .
Click on Validate to launch the building process, on
To overcome O2 level variation around the fume safety setting, the job will start only if the O2 level is
lower than 90% of the fume safety setting .
Interrupt a job
During the manufacturing, it is possible to interrupt the job by clicking the pause button
will finish the current layer, and the Cycle interruption message will be displayed . Click on
completely stop the manufacturing .
3D SYSTEMS, INC.
Delay to use the delay start function, or
48
Quit to cancel .
. When activated, the printer
to continue the job, or on
PN:80-D27 Rev.B
to