3D Systems ProX DMP 300 User Manual page 53

3
Information area
• ATMOSPHERE
Gas
• (mode of the gas supplied): REGUL (regulation around an oxygen target value), DIRECT (continuous injection of
gas at a constant rate), OFF (no gas injection),
• Status of the gas valve indicator : if green, the valve is opened,
• O2 value: current oxygen level value in PPM (particles per million) on the manufacturing chamber,
• O2 setpoint: oxygen level target value,
• Enclosure pressure: current pressure value on the manufacturing chamber,
Enclosure temperature: current temperature value on the manufacturing chamber .
•
• LENS CLEANER
Turbine: state of the lens cleaner blower (turbine) . If green/white, the blower is operating/not operating,
•
Setpoint: setpoint of the blower operating, in %,
•
Differential pressure
•
• PART
Clamping: status of the base plate clamp . If green/white, clamping is ON/OFF,
•
Available powder: the height of the powder available in the feeding piston in mm,
•
Zero sintering: the zero position of the sintering piston in mm .
•
• LASER/OPTIC
• Defocus: defocusing value in mm,
• Laser power: current Laser power, in % .
3D SYSTEMS, INC.
: [Outlet Pressure – Inlet Pressure] of the external filter.
49
PN:80-D27 Rev.B