Processing Alarms And Fault Records - GE MiCOM P747 Agile Technical Manual

Chapter 4 - Configuration
1. A flashing cursor shows which character field of the password can be changed. Press the up or down
cursor keys to change each character (tip: pressing the up arrow once will return an upper case "A" as
required by the default level 3 password).
2. Use the left and right cursor keys to move between the character fields of the password.
3. Press the Enter key t o confirm the password. If you enter an incorrect password, an invalid password
message is displayed then the display reverts to Enter password. On entering a valid password a
message appears indicating that the password is correct and which level of access has been
unlocked. If this level is sufficient to edit the selected setting, the display returns to the setting page to
allow the edit to continue. If the correct level of password has not been entered, the password prompt
page appears again.
4. To escape from this prompt press the Clear key. Alternatively, enter the password using the
Password setting in the SYSTEM DATA column. If the keypad is inactive for 15 minutes, the
password protection of the front panel user interface reverts to the default access level.
To manually reset the password protection to the default level, select Password, then press the CLEAR key
instead of entering a password.
Note:
In the SECURITY CONFIG column, you can set the maximum number of attemps, the time window in which the
failed attempts are counted and the time duration for which the user is blocked.
2.6

PROCESSING ALARMS AND FAULT RECORDS

If there are any alarm messages, they will appear on the default display and the yellow alarm LED flashes.
The alarm messages can either be self-resetting or latched. If they are latched, they must be cleared
manually.
1. To view the alarm messages, press the Read key. When all alarms have been viewed but not cleared,
the alarm LED changes from flashing to constantly on, and the latest fault record appears (if there is
one).
2. Scroll through the pages of the latest fault record, using the cursor keys. When all pages of the fault
record have been viewed, the following prompt appears.
3. To clear all alarm messages, press the Clear key. To return to the display showing alarms or faults
present, and leave the alarms uncleared, press the Read key.
4. Depending on the password configuration settings, you may need to enter a password before the
alarm messages can be cleared.
5. When all alarms are cleared, the yellow alarm LED switches off. If the red LED was on, this will also
be switched off.
62
Enter Password
Press Clear To
Reset Alarms
MiCOM P747
P747-TM-EN-1
P747-TM-EN-1.1