Displaying The Program In The Preview - Siemens SINUMERIK 840D sl Operating Manual

10.7

Displaying the program in the Preview.

You can show the content on a program in a preview before you start editing.
Procedure
Universal
Operating Manual, 02/2011, 6FC5398-6AP40-0BA0
3. Enter the desired search term in the "Text" field.
Note: When searching for a file, enter the complete name with
extension (e.g. DRILLING.MPF).
4. When required, activate the checkbox "Observe upper and lower case".
5. Press the "OK" softkey to start the search.
6. If a corresponding directory or file is found, then it is marked.
7. Press the "Continue search" and "OK" softkeys if the directory or the file
does not correspond to the required result.
- OR -
Press the "Cancel" softkey when you want to cancel the search.
1. Select the "Program manager" operating area.
2. Select a storage location and place the cursor on the relevant program.
3. Press the ">>" and "Preview window" softkeys.
The "Preview: ..." window opens.
4. Press the "Preview window" softkey again to close the window.
Program management
10.7 Displaying the program in the Preview.
235