Executing An Mda Program - Siemens SINUMERIK 840D sl Operating Manual

2.9.3

Executing an MDA program

Proceed as follows
When executing the G-code commands, you can control the sequence as follows:
● Executing the program block-by-block
● Testing the program
● Setting the test-run feedrate
See also
Program control (Page 107)
Universal
Operating Manual, 02/2011, 6FC5398-6AP40-0BA0
1. Select the "Machine" operating area.
2. Press the <MDA> key.
The MDA editor opens.
3. Input the desired G-code commands using the operator's keyboard.
4. Press the <CYCLE START> key.
The control executes the input blocks.
Settings under program control
Settings under program control
Setting up the machine
2.9 MDA
77