Teach In Rapid Traverse G0; Teach In Straight G1; Teaching In Circle Intermediate And Circle End Point Cip - Siemens SINUMERIK 840D sl Operating Manual

Teaching in a program
8.4 Teach-in via Windows
8.4.2

Teach in rapid traverse G0

You traverse the axes and teach-in a rapid traverse block with the approached positions.
Note
Selection of axes and parameters for teach-in
You can select the axes to be included in the teach-in block in the "Settings" window.
You also specify here whether motion and transition parameters are offered for teach-in.
8.4.3

Teach in straight G1

You traverse the axes and teach-in a machining block (G1) with the approached positions.
Note
Selection of axes and parameters for teach-in
You can select the axes to be included in the teach-in block in the "Settings" window.
You also specify here whether motion and transition parameters are offered for teach-in.
8.4.4

Teaching in circle intermediate and circle end point CIP

Enter the intermediate and end positions for the circle interpolation CIP. You teach-in each of
these separately in a separate block. The order in which you program these two points is not
specified.
Note
Make sure that the cursor position does not change during teach-in of the two positions.
You teach-in the intermediate position in the "Circle intermediate position CIP" window.
You teach-in the end position in the "Circle end position CIP" window.
176
Operating Manual, 02/2011, 6FC5398-6AP40-0BA0
Universal