Dc-545: Auto Cut Function - Duplo DocuCutter DC-545 Service Training Manual

IMPORTANT NOTE ON AUTO CUT
AUTOCUT is
possible in
these
sections only
34
DocuCutter 545

DC-545: AUTO CUT function

When AUTO CUT is ON, it works under the following
conditions :
The first cut in the preset program is longer than 17.0
mm.
The distance between the total length entered in the
program and the last cut position entered in the program
is longer than 21.0 mm.
Auto cut works on:
a) The section between the lead edge and CUT 1
and/or
b) The section between the last CUT in the preset
program and the trail edge only. If you want to
have the any other margin cut into pieces, make
sure to add 'dummy' cuts of less than 17 mm in the
program. Otherwise, the margin cut can be left in
the machine or ejected on the paper tray.
DocuCutter 545 Training Guide
Lead edge
CUT1
T1
To cut this part into pieces, add
'dummy' cuts of less than 17.0mm
in the program.
Last CUT
© 2002, Duplo USA Corporation