Table of Contents
Advertisement
ECP Status Codes
When the 7847i-E is configured for ECP mode, it sends status messages to the control panels
(e.g., VISTA-10P, VISTA-15P and VISTA-20P series), for tamper, and network connectivity
failures. Some of the control panels display these on the keypad as "LngRng Radio" followed
by a 4-digit code (listed in table 4). In addition, the Contact ID codes (listed in Appendix B)
for these conditions are sent to the central station by the module.
STATUS CODE
Alternative Zone Trigger Mode
Zone Trigger Mode
There are six input zones available on the 7847i-E. Zones 1 and 2 are located on TB1 pin 5
and are selectable for +V, –V, or EOLR modes, which can detect both pulsed and steady
signals. The pulsed signal is reported as an alarm on zone 1 (Fire); the steady signal is
reported as an alarm on zone 2 (Burg). The implied pulse count for zone 1 is fixed to 3
pulses. No restores are reported for this zone.
Zones 3, 4, 5, 6 and 7 are voltage trigger inputs located on TB1 pins 6-10.
Alternative Mode Programming
Press the [ENTER] key to begin programming
operation being programmed.
NOTE: The central station can remotely block access to
PROMPTS
Strt Prog Mode?
1
Y/N_
Enter Password
2
Program Device?
3
Y/N_
Create Password?
4
Y/N_
Change Password?
5
Table 4. Common ECP Keypad Displays Status Codes
DESCRIPTION
0000
Control panel lost communication
0880
T
detected (cover removed).
amper
0005
Lost Ethernet connectivity.
000F
Not registered; account not activated.
0400
P
on reset AND the control panel lost communications with 7847i-E.
ower
0C80
P
on reset AND tamper detected.
ower
0C8F
P
on reset AND tamper detected AND not registered.
ower
local device programming. If this has been done,
the following prompt appears:
Table 5: Programming a 7847i-E for Zone Trigger mode.
ZONE
ENTRY
TRIG.
ollow the prompts for the mode of
and f
OPTIONS
Enters programming mode.
[Y], [N]
[0-9, A-F, N,
If a password has been previously assigned, this
S, T, X, Y]
prompt appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
The next prompt appears.
[Y], [N]
To begin programming the module, press [Y] and go to
Prompt 9: "Device Mode."
To create a password if none has been assigned,
press [N] and go to Prompt 4: Create Password.
To change an existing password, press [N] and go to
Prompt 5: "Change Password."
[Y], [N]
Passwords can be used to protect account and
programming information. If no password has been
assigned, this prompt appears after pressing [N] at the
"Program Device?" prompt.
If a password is desired, press [Y] and go to Prompt 6:
"Enter Password."
If a password has already been assigned, this prompt
[Y], [N]
appears after pressing [N] at the "Program Device?"
Section 3: Programming the 7847i-E
.
with 7847i-E
Access to Prog
Mode Denied
DESCRIPTION
3-7
Hide quick links:
Advertisement
Table of Contents
