Cellular Status Displays (Appear Only If The Communication Path Includes Cell) - Honeywell HWF2V-COM Installation And Setup Manual

[D]

Cellular Status Displays (appear only if the communication path includes cell)

[E]
NOTE: The following displays except Encryption Test are displayed only if the communication
path includes IP.
Physical Link
Good/Bad
NIC IP Address
xxx.xxx.xxx.xxx
Subnet Mask
xxx.xxx.xxx.xxx
Gateway IP Addr
xxx.xxx.xxx.xxx
DNS Serv IP
xxx.xxx.xxx.xxx
Encryption Test
AES Passed!
DHCP
OK
Operating with Cellular Service
RAT SigQuaI REG
LTE/3G ***** x
Press the [space] key to
go to the next screen.
Press the [backspace]
key to go to the last
screen.
Network Diagnostics Display
Indicates whether the device has detected a physical connection
to the internet.
Press the [Space] key to go to the next field.
IP Information Display
Displays the IP address assigned to this device.
Press the [Space] key to go to the next field.
Displays the 32-bit address mask used to indicate the portion
(bits) of the IP address that is being used for the subnet address.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
Displays the IP address assigned to the Gateway.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
Displays the IP address assigned to the DNS (Domain Name
System) server.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
Performs a self-test of the AES encryption algorithm.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
DHCP (Dynamic Host Configuration Protocol) indicates server is
performing satisfactorily.
Press the [Space] key to go to the Physical Link display.
Cellular Status Display Screen 1
RAT – Radio Access Technology. – LTE or 3G
SigQual – Signal Quality (1-5 "*')
REG – Registration status where "x" can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
If the RAT is LTE, the number of stars is derived from received
power (RSRP) and the received quality (RSRQ). The lower
number of stars of the two ratings is what is displayed as over-
all quality.
NOTE: For adequate signal strength, must be 2 stars or more.
RSRP:
Greater than -85dBm = 5 stars
-86dBm to -95dBm = 4 stars
-96dBm to -105dBm = 3 stars
-106dBm to -115dBm = 2 stars
-116dBm and lower = 1 star
12
RSRQ:
Greater than -10dB = 5
stars
-11dB to -12dB = 4 stars
-13dB to -14dB = 3 stars
-15dB to -16dB = 2 stars
-17dB and lower = 1 star