Cisco CDB-8U Installation Manual page 24

Safety Warnings
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions
Warning
to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing
the unit in the rack.
Statement 1006
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry tub,
Warning
in a wet basement, or near a swimming pool. Statement 1035
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning This product requires short-circuit (overcurrent) protection, to be provided as part of the building installation.
Install only in accordance with national and local wiring regulations.Statement 1045
When installing or replacing the unit, the ground connection must always be made first and disconnected
Warning
last. Statement 1046
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of: <113°F (45°C) up to 10,000 ft and <122°F(50°C) up to 5000 ft.
Statement 1047
Catalyst Digital Building Series Switch Hardware Installation Guide
14
Switch Installation