Installing The Cisco Microsoft Windows Usb Device Driver; Installing The Cisco Microsoft Windows Xp Usb Driver - Cisco CDB-8U Installation Manual

Installing the Cisco Microsoft Windows USB Device Driver

Step 2 Connect a USB cable to the PC USB port. Connect the other end of the cable to the switch micro-B
(5-pin-connector) USB console port.
Step 3 Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC application
such as HyperTerminal or ProcommPlus, makes communication between the switch and your PC or terminal
possible.
Step 4 Configure the baud rate and character format of the PC or terminal to match the console port default
characteristics:
• 9600 baud
• 8 data bits
• 1 stop bit
• No parity
• None (flow control)
Step 5
Power on the switch.
Step 6 The PC or terminal displays the bootloader sequence. Press Enter to display the setup prompt. Follow the
steps in the Setup program.
Installing the Cisco Microsoft Windows USB Device Driver
A USB device driver must be installed the first time a Microsoft Windows-based PC is connected to the USB
console port on the switch.
•
•
•

Installing the Cisco Microsoft Windows XP USB Driver

Procedure
Step 1
Obtain the Cisco USB console driver file from the Cisco.com web site and unzip it.
Note
Catalyst Digital Building Series Switch Hardware Installation Guide
96
Installing the Cisco Microsoft Windows XP USB Driver
Installing the Cisco Microsoft Windows 2000 USB Driver
Installing the Cisco Microsoft Windows Vista and Windows 7 USB Driver
You can download the driver file from the Cisco.com site for downloading the switch software.
Configuring the Switch