Phasor Measurement Unit - GE UR T60 Instruction Manual

5 SETTINGS
a) MAIN MENU

PATH: SETTINGS SYSTEM SETUP
 PHASOR MEASUREMENT
 UNIT
MESSAGE
The T60 Transformer Protection System is provided with an optional phasor measurement unit feature.
This feature is specified as a software option at the time of ordering. The number of phasor measurement
units available is also dependent on this option. Refer to the Ordering section of chapter 2 for additional
details.
The

PHASOR MEASUREMENT UNIT

source, ID and station name, calibration data, triggering, recording, and content for transmission on each of the supported
ports. The reporting ports menus allow specifying the content and rate of reporting on each of the supported ports.
Precise IRIG-B input is vital for correct synchrophasor measurement and reporting. A DC level shift IRIG-B receiver
must be used for the phasor measurement unit to output proper synchrophasor values.
NOTE
The PMU settings are organized in logical groups as follows.

PATH: SETTINGS SYSTEM SETUP
 PHASOR MEASUREMENT
 UNIT 1
MESSAGE
MESSAGE
MESSAGE
MESSAGE
GE Multilin

PHASOR MEASUREMENT UNIT
 PHASOR MEASUREMENT
 UNIT 1
 REPORTING OVER
 NETWORK
menu allows specifying basic parameters of the measurements process such as signal

PHASOR MEASUREMENT UNIT
 PMU 1 BASIC
 CONFIGURATION
 PMU 1
 CALIBRATION
 PMU 1
 COMMUNICATION
 PMU 1
 TRIGGERING
 PMU 1
 RECORDING
T60 Transformer Protection System
5.4.8 PHASOR MEASUREMENT UNIT
See below.
See page 5-120.

PHASOR MEASUREMENT UNIT 1
See page 5-106.
See page 5-107.
See page 5-108.
See page 5-110.
See page 5-117.
5.4 SYSTEM SETUP
5
5-105