GE UR T60 Instruction Manual page 138

4.3 FACEPLATE INTERFACE
2. Press the MESSAGE RIGHT key until the
3. Press the MESSAGE DOWN key until the
4. Press the MESSAGE RIGHT key until the
appears on the display.
 SECURITY

5. After the
CHANGE...PASSWORD
4
selection to "Yes".
6. Press the ENTER key and the display will prompt you to
7. Type in a numerical password (up to 10 characters) and press the ENTER key.
8. When the
VERIFY NEW PASSWORD
CHANGE SETTING
PASSWORD: No
CHANGE SETTING
PASSWORD: Yes
9. When the
NEW PASSWORD HAS BEEN STORED
active.
f) CHANGING EXISTING PASSWORD
To change an existing password, follow the instructions in the previous section with the following exception. A message will
prompt you to type in the existing password (for each security level) before a new password can be entered.
In the event that a password has been lost (forgotten), submit the corresponding encrypted password from the
menu to the Factory for decoding.
SECURITY
g) INVALID PASSWORD ENTRY
By default, when an incorrect Command or Setting password has been entered via the faceplate interface three times
within three minutes, the
command level access via the faceplate interface for the next five minutes.
By default, when an incorrect Command or Setting password has been entered via any external communications interface
three times within three minutes, the
allow settings or command access via the any external communications interface for five minutes. The
FlexLogic™ operand is set to "Off" after five minutes for a Command password or 30 minutes for a Settings pass-
DENIED
word.
These default settings can be changed in EnerVista under Settings > Product Setup > Security.
4-28
ACCESS LEVEL
CHANGE LOCAL PASSWORDS
CHANGE SETTING PASSWORD
ACCESS LEVEL:
Restricted
 CHANGE LOCAL
 PASSWORDS
message appears on the display, press the VALUE UP or DOWN key to change the
is displayed, re-type in the same password and press ENTER.
ENTER NEW
PASSWORD: ##########
message appears, your new Setting (or Command) Password will be
FlexLogic™ operand is set to "On" and the T60 does not allow settings or
LOCAL ACCESS DENIED
REMOTE ACCESS DENIED
T60 Transformer Protection System
message appears on the display.
message appears on the display.
or
CHANGE COMMAND PASSWORD
CHANGE COMMAND
PASSWORD: No
CHANGE SETTING
PASSWORD: No
ENCRYPTED COMMAND
PASSWORD: ---------
ENCRYPTED SETTING
PASSWORD: ---------
.
ENTER NEW PASSWORD
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED
FlexLogic™ operand is set to
4 HUMAN INTERFACES
message
PASSWORD
On and the T60 does not
" "
REMOTE ACCESS
GE Multilin