Table of Contents
Advertisement
4.3 FACEPLATE INTERFACE
USER-PROGRAMMABLE LEDS
DEFAULT LABELS FOR LED PANEL 2:
The default labels are intended to represent:
•
GROUP 1...6: The illuminated GROUP is the active settings group.
•
SYNCHROCHECK NO1(2) IN-SYNCH: Voltages have satisfied the synchrocheck element.
Firmware revisions 2.9x and earlier support eight user setting groups; revisions 3.0x and higher support
4
six setting groups. For convenience of users using earlier firmware revisions, the relay panel shows eight
NOTE
setting groups. Please note that the LEDs, despite their default labels, are fully user-programmable.
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained
in the following section.
a) ENHANCED FACEPLATE
The following procedure requires the pre-requisites listed below.
•
EnerVista UR Setup software is installed and operational.
•
The T60 settings have been saved to a settings file.
•
The T60 front panel label cutout sheet (GE Multilin part number 1006-0047) has been downloaded from
http://www.gedigitalenergy.com/products/support/ur/URLEDenhanced.doc
•
Small-bladed knife.
This procedure describes how to create custom LED labels for the enhanced front panel display.
1.
Start the EnerVista UR Setup software.
4-18
Figure 4–20: LED PANELS 2 AND 3 (INDEX TEMPLATE)
Figure 4–21: LED PANEL 2 (DEFAULT LABELS)
T60 Transformer Protection System
4 HUMAN INTERFACES
USER-PROGRAMMABLE LEDS
4.3.3 CUSTOM LABELING OF LEDS
and printed.
842782A1.CDR
GE Multilin
Advertisement
Table of Contents
