Disassembly Guide
Monitor
Assembly
54
Figure 9: Separating Case Halves
1. Connect the monitor's Power Supply to J16 on the User Interface PCB.
2. Place the monitor's top case over the bottom case, being careful to align
the Display PCB, Power Entry Module, and the fan with the slots in the
case halves.
Caution: When reassembling the N-595, tighten the screws that hold the
cases together to a maximum of 10 inch-pounds. Over-tightening could
strip out the screw holes in the top case, rendering it unusable.
3. Install the four corner screws.