Trend Data Printout (Ascii Mode); Table 19: Operating Status Codes - Nellcor OXIMAX N-595 Service Manual

Data Port Interface Protocol
Trend Data
Printout (ASCII
Mode)
104

Table 19: Operating Status Codes

Code
AO Alarm Off
AS Alarm Silence
BU Battery in Use
LB Low Battery
LM Loss of Pulse with Motion
LP Loss of Pulse
MO MOtion
PH Pulse Rate Upper Limit Alarm
PL Pulse Rate Lower Limit Alarm
PS Pulse Search
SD Sensor Disconnect
SH Saturation Upper Limit Alarm
SL Saturation Lower Limit Alarm
- - - No Data Available
* Alarm Parameter Being Violated
Note: A Sensor Disconnect will also cause three dashes (- - -) to be
displayed in the patient data section of the printout.
The format of data displayed when a trend printout is requested is similar to
that of the real-time data. The only differences are that "TREND" is displayed
in the top row instead of the "CRC:XXXX" software verification number, and
there is no "Status" column (Figure 22 on page 105).
Readings are displayed in 4-second intervals. The values on each row are an
average for the 4-second period.
At the end of the printout, an "Output Complete" line indicates that the
transmission was successful. If the "Output Complete" line is not present, the
data should be considered invalid.
Meaning