Monitor Disassembly; Figure 6-2: Npb-190 Corner Screws - Nellcor NPB-190 Service Manual

6.4

MONITOR DISASSEMBLY

Caution: Observe ESD (electrostatic discharge) precautions when
disassembling and reassembling the NPB-190 and when handling any of the
components of the
NPB-190.
1. Set the NPB-190 upside down, as shown in Figure 6-2.

Figure 6-2: NPB-190 Corner Screws

2. Remove the four corner screws.
3. Turn the unit upright. Separate the top case from the bottom case of the
monitor being careful not to stress the wire harnesses between the cases.
Place the two halves of the monitor on the table as shown in Figure 6-3.
4. Disconnect the Power Supply from J6 on the UIF PCB.
Section 6: Disassembly Guide
Corner screws
6-3