Operational Setup
Alarms and Alarm
Silence
N-595
Operational set up procedures verify and setup the following parameters.
•
Alarms and Alarm Silence, page 15
•
Alarm Volume Control, page 17
•
Pulse Tone Volume Control, page 17
•
Nurse Call, page 18
•
Analog Output, page 19
•
Operating on Battery Power, page 20
1. Connect the DOC-10 monitor cable to the monitor sensor port.
2. Connect the DS-100 sensor to the DOC-10 cable and yourself.
3. Press the POWER ON/OFF button to turn the monitor on.
4. Press the SETUP softkey.
5. Press the VIEW softkey.
6. Press the PLETH softkey. Verify that the %SpO
SpO
and pulse rate.
2
7. Press the LIMITS softkey.
8. Press the SELECT softkey to select SpO
1.
Sensor Port
and BPM indicate your
2
lower alarm limit.
2
Performance Verification
15