NetApp StorageGRID Webscale 10.4 Installation And Maintenance Manual page 35

Option
Have DHCP-assigned IP
address
Do not have DHCP-assigned
address
2. Open a web browser on the service laptop, and access the StorageGRID Webscale Appliance
Installer web page:
• Using DHCP:
http://Management_Port_IP:8080
• Not using DHCP:
The StorageGRID Webscale Appliance Installer web page appears.
• If the StorageGRID Webscale Appliance Installer acquired an IP address using DHCP
(version 1.6 or later), the web page looks like this:
• If the StorageGRID Webscale Appliance Installer could not acquire an IP address using
DHCP, the web page looks like this:
These examples show version 1.7 of the StorageGRID Webscale Appliance Installer web
Note:
page. The version number immediately follows the product name in the menu bar. Earlier
versions of this page might not include the version number in the heading.
Attention: If you want to use Aggregated Port Configuration for the StorageGRID Webscale
Grid and Client networks, you must use version 1.7 or greater of the StorageGRID Webscale
Description
Make sure the service laptop and the E5600SG controller are on the same
subnet.
a. Configure the service laptop IP address with 169.254.0.2
b. Connect the service laptop to management port 2 on the E5600SG
controller, using an Ethernet patch cord.
http://169.254.0.1:8080
Installing the appliance hardware | 35