Installing The Hardware - NetApp StorageGRID Webscale 10.4 Installation And Maintenance Manual

Installing the hardware

Installing the hardware involves installing the mounting rails, enclosure, and, for the SG5660, the
drives.
Before you begin
Installation of the StorageGRID Webscale appliance hardware is similar to the installation of the
E2700 and E5600 E-Series storage systems.
You have the following documents:
• NetApp E-Series Storage Systems E2700 Controller-Drive Tray and Related Drive Trays
Installation Guide
NetApp E-Series Storage Systems E5600 Controller-Drive Tray and Related Drive Trays
•
Installation Guide
About this task
Warning:
off the power switch and unplug the power cord.
Warning:
electrical current from the devices, make sure that all of the power cords are disconnected
from the power source.
Warning:
space.
Warning:
of an SFP transceiver because you might be exposed to laser radiation.
The following warning applies to the SG5612 only.
Warning:
component safely.
The following warning applies to the SG5660 only.
Warning:
component safely.
Attention:
location, you must remove all of the drives from the enclosure. Never move or ship the
SG5660 with drives installed.
For additional warnings, refer to the printed Safety Notices document.
Task
Install the mounting rails
Risk of electrical shock - Before removing or installing a power supply, turn
Risk of bodily injury - Each tray has more than one power cord. To remove all
Risk of bodily injury - Do not use equipment in the cabinet as a shelf or work
Risk of exposure to laser radiation - Do not disassemble or remove any part
Risk of bodily injury - Two people or a mechanical lift are required to lift the
Risk of bodily injury - Four people or a mechanical lift are required to lift the
Risk of equipment damage – If you want to move the SG5660 to a new
Description
Install the mounting rails into the cabinet.
Installing the appliance hardware | 21