NetApp StorageGRID Webscale 10.4 Installation And Maintenance Manual page 18

18 | StorageGRID Webscale 10.4 Appliance Installation and Maintenance Guide
Information needed
MAC addresses or IP addresses for management
ports
• If the management network (or networks)
includes a DHCP server, enter the MAC
address from the labels next to management
port 1 on the back of each controller. The
network administrator can use the MAC
address to determine what IP address was
assigned by the DHCP server. (For some
E5600SG controllers, the DHCP-assigned IP
address is displayed on the seven-segment
display after you apply power.)
• If you do not use DHCP, enter the static IP
address that you plan to use for these ports
on your network.
Specify the switch ports you will connect to the
four 10-GbE optical ports on the E5600SG
controller.
If you plan to use Fixed Port
Note:
Configuration, ports 2 and 4 connect to the
Grid network for StorageGRID Webscale,
and ports 1 and 3 connect to the Client
network for StorageGRID Webscale. If you
plan to use Aggregate Port Configuration, see
information about StorageGRID Webscale
appliance connections and cabling the
appliance.
Specify the IP address of the Grid network
interface for StorageGRID Webscale.
Note: This information might not be
available at the time you are performing the
hardware phase of the installation.
Specify the IP address of the Client network
interface for StorageGRID Webscale.
Note: This information might not be
available at the time you are performing the
hardware phase of the installation.
Related tasks
Cabling the appliance
Related references
StorageGRID Webscale appliance connections
on page 23
on page 15
Your value
Address for management port 1 on E2700
controller:
Address for management port 1 on E5600SG
controller:
Switch port for Port 2:
Switch port for Port 4:
Switch port for Port 1:
Switch port for Port 3:
Grid network IP address:
Client network IP address: