L2Tp - D-Link DIR-608 User Manual

Section 3 - Configuration
Click L2TP on the navigation menu to configure L2TP (Layer 2 Tunneling Protocol) connection.
Your ISP will provide you with a server address, username, and password.
Session: Check the radio button to enable L2TP.
Name: Enter a name for your L2TP connection.
LNS IP: Enter the L2TP Server address.
LNS Port:
Enter the L2TP Server port number.
Auth: Select PAP, CHAP, CHAPMSV2, or auto. The default is auto.
User Name:
Enter the username provided by your ISP.
Password:
Enter the password provided by your ISP.
Connection Type: Select either Continuous, Connect on Demand, or Manual.
Idle Time(min): If Connect on Demand is selected, enter a maximum idle time during
which the Internet connection is maintained during inactivity.
NAPT: Check the radio button to enable NAPT.
Default Route: Check the radio button to enable Default Route.
MTU: Enter the MTU size.
When you have finished configuring your L2TP Connection, click the Apply Changes button.
D-Link DIR-608 User Manual
L2TP Settings

L2TP

DIR-608
L2TP
L2TP Settings
Setup
L2TP
Session: Disable Enable
Name:
LNS IP:
LNS PORT: 1701
Authentication:
auto
User Name:
Password:
Connection Type:
Continuous
Idle Time(min): 0
NAPT:
Disable Enable
Default Route: Disable Enable
MTU: 1460
Apply Changes Reset
Wireless
▼
▼
31