Ipv6 Filter - D-Link DIR-608 User Manual

Section 3 - Configuration
This page allows you to configure IPv6 filter rules that determine what kind of traffic is
allowed to pass through the network.
Choose the default action for outgoing IPv6 traffic, either Permit or
Outgoing Default
Deny. The default is Permit.
Action:
Choose the default action for incoming IPv6 traffic, either Permit or
Incoming Default
Deny. The default is Permit.
Action:
Rule Action: Select whether to Permit or Deny IPv6 traffic for this rule.
Protocol: Select the protocol to apply the rule to: IPv6, ICMP6, TCP, or UDP.
ICMP6 Type: If ICMP6 is selected PING6 is the ICMP6 Type.
Direction: Select whether to apply to rule to Upstream or Downstream traffic.
Source IPv6 Enter the source IPv6 address and prefix length to apply the rule to.
Address & Prefix
Length:
Dest IPv6 Address Enter the destination IPv6 address and prefix length to apply the
& Prefix Length: rule to.
SPort: Enter the source port range, if applicable.
D-Link DIR-608 User Manual
Default Action Status
Rule Configuration

IPv6 Filter

DIR-608
Advanced
IP/Port Filtering
IPv6 Filter
Default Action Status
Outgoing Default Action: Permit
Incoming Default Action:
Permit
Rule Configuration
Rule
Permit Deny
Action:
Icmp6
Protocol:
IPv6 ▼
Direction: Upstream ▼
Source
IPv6
Length:
Address:
Dest IPv6
Address: Length:
SPort: - DPort:
☑
Enable:
Apply Changes Reset
Maintenance
Deny
Deny
PING6 ▼
Type:
Prefix
Prefix
-
Help
72