Section 3 - Configuration
These instructions will guide you through setting up your DIR-608 as a wireless repeater in a
few easy steps. Please refer to Wireless Repeater Mode on page 9 for more information.
Step 1: Navigate to the Wireless Repeater section of the web ui, click on the Wireless tab
on the top of the web ui and click Wireless Repeater from the menu on the left hand side
of the screen.
Check the box and click the Apply button in order to enable the
Repeater Enabled:
Wireless Repeater function.
Click the Site Survey button to enable the router to search for nearby
SSID of AP:
wireless networks. This will take about 5 seconds.
A list of wireless networks that have been found will then appear.
Select the wireless network you wish to extend and click the Next
button.
D-Link DIR-608 User Manual
Wireless Repeater Setup
Wireless Repeater Setup
DIR-608
Wireless
Wireless Repeater
Wireless Repeater
Wireless Repeater Setup
Repeater
☑
mode will be set to 'none'
if the repeater is
SSID of AP
#
SSID
MAC Address Channel Signal
1
D-Link
ff:ff:ff:ff
1
100%
Click 'Next' to Continue repeater settings
Next
Apply
Advanced
Enabled(DHCP
enabled)
Site Survey
Security
Select
WPA2-
PSK(TKIP)
58