D-Link DIR-608 User Manual page 60

Section 3 - Configuration
PIN of the router: The WPS PIN will be displayed here.
Enable WPS: Check the box to enable WPS.
Disable PIN: Check to disable WPS PIN.
Keep current Check to keep the current configuration.
configuration:
When you have finished configuring your wireless network, click the Apply Changes button.
Click the ACL Setup button to edit the ACL (Access Control List). This takes you to the screen
below.
Enable Wireless Check the box to enable Wireless Access Control Mode. In this mode,
Access Control only listed wireless devices will be allowed to connect to the wireless
Mode: network.
Click the Apply button when you are done.
If you enabled Wireless Access Control, you may begin adding MAC addresses to the ACL list.
MAC Address: Enter the MAC address of a device you wish to allow access for to
the WLAN and click the Add button. This will add the device's MAC
Address to the ACL table above. To remove a device from the ACL
table, select the MAC address from the above table and click the
Delete button
D-Link DIR-608 User Manual
Advanced Wireless (continued)
WPS Setup
Access Control List
WPS Setup
PIN of the router :
Enable WPS :
Disable PIN :
Keep current configuration :
Apply Changes
Access Control List
ACL Setup
Wireless Access Control Mode
☐
Enable Wireless Access Control Mode
MAC Address
00e086710502
Apply Delete Selected
MAC Address:
(ex: 00e086710502)
Add Cancel
☑
☑
☑
Select
Delete All
56