D-Link DIR-608 User Manual page 41

Section 3 - Configuration
Address Autoconfiguration Settings
Enable Enable or disable the Automatic IPv6 Address Assignment feature.
Autoconfiguation:
Select SLAAC+Stateless DHCP or Stateful DHCPv6.
LAN IPv6 Address:
If you choose SLAAC+Stateless DHCP, please configure the following field:
Router Enter the IPv6 address lifetime (in minutes).
Advertisement
Lifetime:
If you choose Stateful DHCPv6, please configure the following field:
IPv6 Address
Enter the starting IPv6 address for the DHCP server's IPv6 assignment.
Range(Start):
IPv6 Address
Enter the ending IPv6 address for the DHCP server's IPv6 assignment.
Range(End):
Router
Enter the IPv6 address lifetime (in seconds).
Advertisement
Lifetime:
D-Link DIR-608 User Manual
SLAAC/DHCPv6 (continued)
Address Autoconfiguration Settings
Use this section to setup IPv6 Autoconfiguration to assign IP
addresses to the computers on your network.
☑
Enable Autoconfiguration:
LAN IPv6 Address: SLAAC+Stateless DHCP
Router Advertisement
30
Lifetime:
Address Autoconfiguration Settings
Use this section to setup IPv6 Autoconfiguration to assign IP
addresses to the computers on your network.
☑
Enable Autoconfiguration:
LAN IPv6 Address: Stateful(DHCPv6)
IPv6 Address Range(Start): xxxx
IPv6 Address Range(End):
xxxx
Router Advertisement
Lifetime:
▼
(minutes)
▼
::00 3
::00 16
(second)
37