Installation; Before You Begin - D-Link DIR-608 User Manual

Section 2 - Installation
This section will walk you through the installation process. Placement of the router is very important. Do not place the router
in an enclosed area such as a closet, cabinet, or in the attic or garage.
• Configure the router with the computer that was last connected directly to your Internet connection. Verify that
it is connected to the Internet before connecting additional devices.
• If your ISP provided you with a modem/router combo, you will need to set it to "bridge" mode so the router can
work properly. Please contact your ISP or refer to the user manual for your modem/router device.
• You can only use the Ethernet port on your modem. If you were using the USB connection before using the router,
then you must turn off your modem, disconnect the USB cable and connect an Ethernet cable to the Internet
port on the router, and then turn the modem back on. In some cases, you may need to call your Internet Service
Provider (ISP) to change connection types (USB to Ethernet).
• If connecting to a DSL modem, make sure to have your DSL service information provided by your ISP handy. This
information is likely to include your DSL account's username and password. Your ISP may also supply you with
additional WAN configuration settings which might be necessary to establish a connection.
• If you are connecting a considerable amount of networking equipment, it may be a good idea to take the time
to label each cable or take a picture of your existing setup before making any changes.
• If you have DSL and are connecting via PPPoE, make sure you disable or uninstall any PPPoE software such as
WinPoET, BroadJump, or EnterNet 300 from your computer or you will not be able to connect to the Internet.
• If you are using this device as a wireless repeater, you may need to use trial and error to determine an acceptable
placement location.
D-Link DIR-608 User Manual

Installation

Before You Begin

11