Table of Contents
Advertisement
DVG-5402G/GF Wireless AC1200 Wave 2 MU-MIMO Dual
Band Gigabit Router with Fiber WAN Port, 3G/LTE Support,
2 FXS Ports, and USB Port
User Manual
Creating PPTP, L2TP, L2TP Dual Stack, or L2TP over IPsec WAN Connection
On the connection creation page, in the General Settings section, select the relevant value from
the Connection type drop-down list and specify the needed values.
Figure 77. The page for creating a new PPTP connection. The General Settings section.
Parameter
Connection name
Enable connection
NAT
NATv6
Ping
General Settings
A name for the connection for easier identification.
Move the switch to the right to enable the connection.
Move the switch to the left to disable the connection.
If the switch is moved to the right, the network address translation
function for IPv4 is enabled. Do not disable the function unless your
ISP requires this.
For the L2TP Dual Stack type only.
If the switch is moved to the right, the network address translation
function for IPv6 is enabled. Do not disable the function unless your
ISP requires this.
For the PPTP, L2TP, and L2TP Dual Stack types only.
If the switch is moved to the right, the router responds to ping
requests from the external network through this connection. For
security reasons, it is recommended to disable this function.
Page 98 of 352
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
