Port Triggering - D-Link DIR-608 User Manual

Section 3 - Configuration
This page allows you to enable port triggering to specify inbound traffic to be sent to specific
ports while other ports are in use for outbound traffic.
This page allows you to set up an Port Trigger Table to restrict the types of data packets that
can enter the network from the Internet.
NAT Port Trigger: Enable or disable the Nat Port Trigger.
Click the Apply Changes button to save any changes made.
Usual Application
Select an application from the dropdown menu.
Name:
User-defined
Enter the name of an application.
Application Name:
Start Match Port:
Enter a start match port.
End Match Port:
Enter a end match port.
Trigger Protocol:
Select a protocol from the pulldown menu.
Start Relate Port: Enter a start relate port.
End Relate Port: Enter an end relate port.
Open Protocol: Select a protocol from the dropdown menu.
D-Link DIR-608 User Manual

Port Triggering

Port Triggering Status
Application Type
DIR-608
Advanced
Port Triggering
Port Triggering
Port Triggering Status
Nat Port Trigger: Enable
Apply Changes
Application Type
Usual Application Name:
User-defined Application Name:
Start Start End
End Match Trigger
Match Relate Relate
Port Protocol
Port Port Port
▼
UDP
▼
UDP
▼
UDP
Apply Changes
Maintenance
Disable
Select One
▼
Open
Nat Type
Protocol
▼ outgoing ▼
UDP
▼ outgoing ▼
UDP
▼ ▼
outgoing
UDP
62