Maintenance; Recharging And Changing The Battery; Cleaning - AEMC PowerPad 3945 User Manual

Use only factory specifi ed replacement parts. AEMC
for any accident, incident, or malfunction following a repair done other than by its
service center or by an approved repair center.

7.1 Recharging and Changing the Battery

The battery is automatically charged when the unit is connected to AC power.
WARNING:
• When changing the battery, it must be de-energized, the equipment
turned off, and there must be a delay of at least one minute without
the battery being connected.
• Do not expose the battery to heat exceeding 212°F (100°C)
• Do not short-circuit the battery terminals

7.2 Cleaning

Disconnect the instrument from any source of electricity.
• Use a soft cloth, lightly dampened with soapy water
• Wipe with a damp cloth and then dry with a dry cloth
• Do not splash water directly on the clamp
• Do not use alcohol, solvents or hydrocarbons
Power Quality Analyzer Model 3945
C
HAPTER
M
AINTENANCE
7
®
will not be held responsible
79