4 Industrial PC Support Utility
To change PROGRAM mode to RUN mode, click the Run button.
4-6-2
Resetting the Controller
When the Controller stops due to a major fault level Controller error, you can reset the Controller to
restore from the error.
Always confirm the safety of the system before you reset the Controller.
The procedure to reset the Controller is given below.
1
Click the Reset button under Reset Controller.
The following dialog box is displayed if the Controller is in RUN mode.
2
Confirm that no problem will occur even if you change the operating mode, and then click the
Yes button.
A message box appears to confirm resetting the Controller.
3
Confirm that no problem will occur even if you reset the Controller, and then click the Yes but-
ton. A message box appears again to confirm the resetting. Click the Yes button.
When the Controller reset is completed, a completion message box is displayed.
When you click the OK button, the Network Connection dialog box is displayed.
4
Enter the IP address again, and then click the Connect button.
4 - 10
NY-series Industrial Panel PC / Industrial Box PC Setup User's Manual (W568)