If there is no backup file in the selected folder, the following dialog box is displayed. Click the
OK button to close the message box, and then select another folder.
3
Select the check box for the target data to restore, and then click the Execute button.
The following dialog box is displayed if the Controller is in RUN mode.
4
Confirm that no problem will occur even if you change the operating mode, and then click the
Yes button.
A message box appears to indicate the absolute encoder home offset that will be applied.
5
To start restoring the data, click the Yes button.
The restore operation is started. When the restore operation is completed, a message box is
displayed.
When you click the OK button, the Network Connection dialog box is displayed.
6
Enter the IP address again, and then click the Connect button.
NY-series Industrial Panel PC / Industrial Box PC Setup User's Manual (W568)
4 Industrial PC Support Utility
4
4 - 13