Starting And Exiting; Starting - Omron NY532-1500 Setup And User's Manual

2-2

Starting and Exiting

This section gives the basic starting up and exiting operations of the Industrial PC, and the operation
sequences.
2-2-1

Starting

During starting up, the Monitor displays the startup status. The following description assumes that you
are using an Industrial Panel PC, or an Industrial Box PC to which a Monitor is connected.
Startup Operating Modes
The Industrial PC has the following startup operating modes.
Type
Normal mode
Safe mode
The Normal mode operation procedure is given below.
Refer to 8-1 Starting in Safe Mode on page 8 - 2 for information on the Safe mode.
Normal Mode
1
Press and release the power button on the Industrial PC within 1 second.
The PWR LED lights, and the BIOS startup view is displayed on the Monitor.
2
Wait for the RUN LED to light.
The RUN LED flashes, and the Real-Time OS (Controller function) starts up in RUN mode.
When the Controller function is completely started up, the RUN LED lights, and then Windows
starts up.
Additional Information
• The startup state of the Real-Time OS (Controller function) is not shown on the Monitor.
The startup process of the Real-Time OS is completed at the time when the Windows
startup view is displayed.
• Refer to Section 8 Troubleshooting during Setup on page 8 - 1 for details on errors that
occur during startup.
• Other than pressing the power button, you can use an external input signal to start up the
Industrial PC in Normal mode. After the external input signal is turned ON, the same oper-
ations as after the power button is pressed follow. Refer to the NY-series Industrial Box
PC Hardware User's Manual (Cat. No. W556) or the NY-series Industrial Panel PC Hard-
ware User's Manual (Cat. No. W557) for details on the startup procedure with an external
input signal.
NY-series Industrial Panel PC / Industrial Box PC Setup User's Manual (W568)
The mode is used for normal startup. The Controller is started up in RUN mode.
The Controller is started up in PROGRAM mode. This mode is used to start up the Con-
troller in PROGRAM mode even if the operating mode at power ON is set to RUN mode.
2 Initial Settings
Description
2
2 - 5