System Profile Settings Screen - Dell PowerEdge M420 Owner's Manual

Menu Item
Remote Terminal Type Allows you to set the remote console terminal type. By default, the Remote Terminal Type
Redirection After Boot Allows you to enable or disable to the BIOS console redirection when the operating system is

System Profile Settings Screen

Menu Item
System Profile
CPU Power
Management
Memory Frequency Allows you to set the memory frequency. By default, the Memory Frequency option is set to
Turbo Boost
C1E
C States
Monitor/Mwait
Memory Patrol
Scrub
Memory Refresh
Rate
Memory Operating
Voltage
Downloaded from www.Manualslib.com
Description
option is set to VT 100/VT220.
loaded. By default, the Redirection After Boot option is set to Enabled.
Description
Allows you to set the system profile. If you set the System Profile option to a mode other than
Custom, the BIOS automatically sets the rest of the options. You can only change the rest of the
options if the mode is set to Custom. By default, the System Profile option is set to Performance
Per Watt Optimized (DAPC). DAPC is Dell Active Power Controller.
NOTE: The following parameters are available only when the System Profile is set to Custom.
Allows you to set the CPU power management. By default, the CPU Power Management option is
set to System DBPM (DAPC). DBPM is Demand-Based Power Management.
Maximum Performance.
Allows you to enable or disable the processor to operate in turbo boost mode. By default, the
Turbo Boost option is set to Enabled.
Allows you to enable or disable the processor to switch to a minimum performance state when it
is idle. By default, the C1E option is set to Enabled.
Allows you to enable or disable the processor to operate in all available power states. By default,
the C States option is set to Enabled.
Allows you to enable Monitor/Mwait instructions in the processor. By default, the Monitor/Mwait
option is set to Enabled for all system profiles, except Custom.
NOTE: This option can be disabled only if the C States option in Custom mode is disabled.
NOTE: When C States is enabled in Custom mode, changing the Monitor/Mwait setting does
not impact system power/performance.
Allows you to set the memory patrol scrub frequency. By default, the Memory Patrol Scrub
option is set to Standard.
Allows you to set the memory refresh rate. By default, the Memory Refresh Rate option is set to
1x.
Allows you to set the DIMM voltage selection. When set to Auto, the system automatically sets
the system voltage to the optimal setting based on the DIMM capacity and the numbers of
DIMMs installed. By default, the Memory Operating Voltage option is set to Auto.
manuals search engine
17