Replacing The Sd Vflash Card - Dell PowerEdge M420 Owner's Manual

NOTE: If the Redundancy option is set to Mirror mode in the Integrated Devices screen of the system setup, you
must follow the instructions in step 5 through step 7 to avoid loss of data.
2. Remove the blade from the sleeve.
3. If the redundancy option is set to Disabled, replace the failed SD card with a new SD card.
4. Replace the SD card with a new SD card.
5. Install the blade in the sleeve.
6. Enter the System Setup and ensure that the Internal SD Card Port and Redundancy mode is enabled.
7. Ensure that the new SD card is functioning properly.
Figure 22. Replacing the SD Card

Replacing The SD vFlash Card

1. Remove the blade from the sleeve.
2. If installed, remove the SD vFlash card/SD card from the card slot.
3. To install the SD vFlash card, insert the contact-pin end of the SD card into the card slot with the card label side
facing down.
4. Press inward on the card to lock it in the slot.
5. Install the blade in the sleeve.
Downloaded from www.Manualslib.com
1. SD card
2. SD card slot
manuals search engine
51