Inside The Blade
Figure 7. Inside the Blade
1. blade system board release handle
2. mezzanine card blank
3. processor/DIMM blank
4. LOM riser card connector
5. heat sink (for processor 1)
6. memory modules (3) (for processor 2)
7. SSD backplane
8. solid state drives (2)
I/O Module Mezzanine Card
Mezzanine Card Installation Guidelines
•
The blade supports one SFF mezzanine card.
•
The mezzanine card slot supports Fabric B or Fabric C, depending on the slot in the sleeve where the blade is
installed. This card must match the fabric type of the I/O modules installed in the corresponding I/O module
bays.
NOTE: For more information on I/O modules, see "Guidelines for Installing I/O Modules" in the
Owner's Manual at support.dell.com/manuals.
28
Downloaded from
www.Manualslib.com
manuals search engine
9. SD card 1 slot
10. SD vFlash card/SD card 2 slot
11. processor 2 socket
12. memory modules (3) (for processor 1)
13. optional mezzanine card (Fabric B or C)
14. mezzanine card release latch
M1000e Enclosure