System Profile Settings Screen Details - Dell poweredge t330 Owner's Manual

Option Description
External Serial Enables you to associate the External Serial Connector to Serial Device 1, Serial
Connector Device 2, or the Remote Access Device by using this field.
Failsafe Baud Rate Displays the failsafe baud rate for console redirection. The BIOS attempts to
determine the baud rate automatically. This failsafe baud rate is used only if the
attempt fails, and the value must not be changed. This option is set to 115200 by
default.
Remote Terminal Sets the remote console terminal type. This option is set to VT 100/VT 220 by
Type default.
Redirection After Enables or disables the BIOS console redirection when the operating system is
Boot loaded. This option is set to Enabled by default.

System Profile Settings screen details

You can use the System Profile Settings screen to enable specific system performance settings such as
power management.
To view the System Profile Settings screen, click System Setup Main Menu → System BIOS → System
Profile Settings.
The System Profile Settings screen details are explained as follows:
Option Description
System Profile Sets the system profile. If you set the System Profile option to a mode other than
Custom, the BIOS automatically sets the rest of the options. You can only change
the rest of the options if the mode is set to Custom. This option is set to
Performance Per Watt (OS).
CPU Power Sets the CPU power management. This option is set to OS DBPM by default. DBPM
Management is Demand-Based Power Management.
Memory Sets the speed of the system memory. You can select Maximum Performance,
Frequency Maximum Reliability, or a specific speed.
Turbo Boost Enables or disables the processor to operate in turbo boost mode. This option is
set to Enabled by default.
NOTE: Every time the system boots, the BIOS syncs the serial MUX setting
saved in iDRAC. The serial MUX setting can independently be changed in
iDRAC. Loading the BIOS default settings from within the BIOS setup utility
may not always revert the serial MUX setting to the default setting of Serial
Device 1.
NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use
console redirection by SOL, configure the same port address for console
redirection and the serial device.
NOTE: Every time the system boots, the BIOS syncs the serial MUX setting
saved in iDRAC. The serial MUX setting can independently be changed in
iDRAC. Loading the BIOS default settings from within the BIOS setup utility
may not always revert this setting to the default setting of Serial Device 1.
NOTE: All the parameters on the system profile setting screen available only
when the System Profile option is set to Custom.
41