Checking The Measurement Condition - Mitsubishi Electric AG-150A Instruction Book

3-4

Checking the Measurement Condition

Text below explains how to check the measurement condition either by list or graph.
Note: An AI controller (PAC-YG63MCA) and a commercially available temperature sensor and humidity sensor are
required to measure the temperature and humidity.
Note: A PI controller (PAC-YG60MCA) and a commercially available pulse output meter are required to measure
the electric, water, heat, and gas consumptions.
3-4-1 Using a measurement list
Click [Monitor/Operation] in the menu, and click [Measurement List] in the sub menu to display a list of the
measurement condition.
Update to most recent
condition
Click to update the screen so
that the most recent operation
condition is shown.
Measured item
The measured item is
displayed here.
Measurement value
The measurement value is
displayed here.
Item
Trend graph
Update to most recent
condition
Expansion Controller
system selection
buttons
Measurement value
Switches to the screen where the measurement value can be checked by graph.
Click [Update] to ensure the displayed items reflect the most recent operation condition.
When [Auto] is selected, information is updated automatically every minute to reflect the latest
information.
Click the button that corresponds to the desired Expansion Controller system to display the
measuring units in the system.
Note: Expansion Controller system selection buttons will not appear if no PAC-YG50ECA
Expansion Controllers are connected.
The present value is displayed.
Note: The following icons are used to indicate the measuring devices. The icon is displayed
in orange when the measured value exceeds the upper limit alarm value or the lower
limit alarm value that is set on Initial Setting Web
Temperature
sensor
Humidity sensor
Drop meter
*1 When there is a communication error or a sensor error, the temperature and humidity
sensors' readings will be "- -".
*2 When there is a communication error, the drop meter's reading will be the measured
value immediately before the error detection.
Description
Upper/lower limit
Normal
alarm
21
Trend graph
Click to display the trend
graph for each
measurement value.
Expansion Controller
system selection button
Click to display the desired
system.
.
Communication
error
*1
*1
*2