Mitsubishi Electric AG-150A Instruction Book page 30

Select the name of the block that the group belongs to, and then
select the group name in the Setting Object box.
Alternatively it is possible to just select the group name and the group
number. Once the group is selected, the contents of the schedule
saved for that group will be displayed in the Contents of Schedule box.
Note: If Expansion Controllers are connected, Expansion Controller system
selection buttons will appear. Select the button that corresponds to the
desired system (EC1, EC2, or EC3), and then select the groups in the
system.
In the Group Name field, all groups in all Expansion Controller systems
are available for selection. (If no name is assigned to a given group, it will
appear in the [Expansion Controller number + Group number] format
(e.g., Group 1-35)).
(1-2)Select all groups in a block
If you want to set a schedule to be used by all groups in a block, select
[Block] from the Setting Range box.
Select the name of the block that the groups belong to from the
Setting Object box. Alternatively, if you click on a group number, the
block that the group belongs to gets selected (groups cannot be
selected unless they belong to a block).
Note: If Expansion Controllers are connected, Expansion Controller
system selection buttons will appear. Select the button that
corresponds to the desired system (EC1, EC2, or EC3), and then
select the groups in the system.
When air conditioner groups, ventilator (LOSSNAY) groups, Air To
Water (PWFY) groups, and general equipment groups exist together
in the selected block, a new screen will appear to select the group.
Click one of the [All Air-conditioners in this block], [All LOSSNAY in
this block], [All Air To Water in this block], or [Other Equipment] and
the screen to set the batch operation will appear.
If the system has only air conditioner groups or only LOSSNAY
groups or only Air To Water (PWFY) groups or only general
equipment groups, this selection screen will not appear.
Next a screen to select the schedule setup method will appear. Select
either [New settings] or [Based on the following group settings]. If you
plan to add to an existing setting, and then choose to base it on an
existing setting and select the name of the group you want to base the
setting on and click the [OK] button.
If you chose to make a new setting, the Contents of Schedule box will
appear completely blank. If you chose to base your setting on an
existing group, the contents of the schedule set for that group will appear in the Contents of Schedule box.
30