Mitsubishi Electric AG-150A Instruction Book page 34

(1-2)Select all groups
When you want to set a schedule that will apply to all groups, select
[All Group] in the Setting Range box.
Next a screen to select the schedule setup method will appear. Select
either [New settings] or [Based on the following group settings]. If you
plan to add to an existing setting, and then choose to base it on an
existing setting and select the name of the group you want to base the
setting on and click the [OK] button.
If you chose to make a new setting, the Contents of Schedule box will
appear completely blank. If you chose to base your setting on an
existing group, the contents of the schedule set for that group will
appear in the Contents of Schedule box.
(2)Set the starting and ending dates for each scheduled type.
Follow the same procedures as outlined in section 3-7-1-1(2).
(3)Select the day of the week.
Follow the same procedures as outlined in section 3-7-1-1(3).
(4)Set the contents of the schedule
When one of the [Edit] buttons in the Contents of Schedule box is
clicked, a screen to set a schedule operation will appear. Use this
screen to set when to run an operation and set the type of schedule
operation (ON/OFF, operation mode, temperature setting, prohibit
remote controller operation) and then press the [OK] button.
It is possible to schedule operation by specifying the settings for
selected items (e.g., operation mode only or preset temperature only).
(5)Copy a schedule to another day of the week or to another group.
Follow the same procedures as outlined in section 3-7-1-1(5).
(6)Save the contents of schedule.
Follow the same procedures as outlined in section 3-7-1-1(6).
34