Mitsubishi Electric AG-150A Instruction Book page 19

3-3-1-2 Performing the operations that target one block
(1) Select the block you want to operate as an entire block from the
operation condition monitoring screen for block lists and click
[Batch Operation]. When air conditioner groups, ventilator
(LOSSNAY) groups, and general equipment groups exist together
in the selected block, a new screen will appear to select the group.
Click one of the [All Air-conditioners in this block], [All LOSSNAY
in this block], [All Air To Water in this block], or [Other Equipment]
and the screen to set the batch operation will appear.
If the block that was selected has only air conditioner groups or
only LOSSNAY groups or only Air To Water (PWFY) groups or
only general equipment groups, this selection screen will not
appear.
(2) After you have made the settings on the screen for batch
operation, click [OK] and the operation settings for only the
adjusted items will be sent to all the air conditioner, ventilator
(LOSSNAY) groups, Air To Water (PWFY) groups, or general
equipment groups contained in the selected block.
To return to the previous screen without performing any
operations, click [Cancel].
Note: When resetting the filter sign as part of a one-block batch
operation, the accumulated ON time used to trigger the filter sign
will be reset in all units belonging to the selected block,
irrespective of whether or not the filter sign was triggered. Use
the reset filter sign operation in a batch operation in a case such
as when all the unit filters in the same batch are cleaned at once.
Note: When allowing remote controller operation under K control, all prohibit remote controller operation items must
be set enable.
3-3-1-3 Performing the operations that target all groups
(1) Click [Batch Operation] from the operation condition monitoring
screen that displays all groups in a list. When air conditioner
groups, ventilator (LOSSNAY) groups, and general equipment
groups exist together in the system, a new screen will appear to
select the group. Click one of the [All Air-conditioners],
[All LOSSNAY], [All Air To Water], or [Other Equipment] and the
screen to set the batch operation will appear.
If the system has only air conditioner groups or only LOSSNAY
groups or only Air To Water (PWFY) groups or only general
equipment groups, this selection screen will not appear.
(2) After you have made the settings on the screen for batch
operation, click [OK] and the operation settings for only the
adjusted items will be sent to all the air conditioner, ventilator
(LOSSNAY) groups, Air To Water (PWFY) groups or general
equipment groups.
To return to the previous screen without performing any
operations, click [Cancel].
Note: When resetting the filter sign as part of an all-groups batch
operation, the accumulated ON time used to trigger the filter sign
will be reset in all units, irrespective of whether or not the filter
sign was triggered. Use the reset filter sign operation in a batch
operation in a case such as when all the unit filters are cleaned at
once.
Note: When allowing remote controller operation under K control, all prohibit remote controller operation items must
be set enable.
19