Toshiba e-STUDIO477S Service Manual page 88

 45060401PA Roller-Assy-Eject-ADF
Lever-Separator-EX
Washer-A
EM-30LP Class A
Apply a little amount of MOLYKOTE
(EM-30LP) to the hatched area.
HANARL SF-133 All around
Apply HANARL (SF-133) all around
of 44535301 Gear-Shaft-R3
Leave it for about 3minutes (drying time) after painting HANARL SF-133, and then
assemble the roller.
45387101TH Rev.1
 45060601PA Plate-Assy-Gear
Roller-Feed-ADF
 45060501PA Pulley-Assy-Idle
HANARL SF-133 All around
Apply HANARL (SF-133) to
45050301 Plate-Gear(Caulking
Especially,to 2 shaft
EM-30LP Class C x1
Apply Class C of MOLYKOTE (EM-30LP)
to the hatched area. (to 1 places on the gear tooth
circle) (Refer to detail)
Leave it for about 3minutes (drying time) after painting HANARL SF-133, and then
assemble the roller.
Leave it for about 3minutes (drying time) after painting HANARL SF-133, and then
assemble the roller.
3. Component replacement
HANARL SF-133 All around
Apply HANARL (SF-133) to
45048601 Plate-Pulley(Caulking)
Especially, to the shaft.
3-50 /