3.2.31 Guide-Retard / Roller / Motor / Clutch / Solenoid/
Photo-sensor
(1) Pull and remove Guide-Cable-ADF ① .
(2) Remove the E ring ② and remove the clutch ③ .
(3) Remove the three screws(black/6mm) ④ and remove the plate-motor-ADF ⑤ .
(4) Remove the two screws(silver) ⑥ and remove the motor-pulse ⑦ from ⑤ .
(5) Remove the E ring ⑧ and remove the clutch ⑨ .
(6) Open the Cover-Assy-Top-ADF ⑩ , and warp around a post to Arrow A to remove
Cover-Assy-Top-ADF ⑩ .
(7) Disconnect a cable, and warp around post to Arrow B to remove the Guide-
Retard-A ⑪ .
(8) Remove the Guide Separator Hop ⑫ .
(9) Remove the three screws(black / 6mm) ⑬ and Plate-Drive ⑭ .
(10) Remove the Feed roller ⑮ .
(11) Remove two screws (silver) ⑯ and remove the solenoid ⑰ .
(12) Warp around post to Arrow C to remove Guide-B ⑱ .
(13) Warp around post to Arrow E to remove Guide-Separator ⑲ .
(14) Disconnect all cables and warp around post to Arrow D to remove the Guide-
Assy-C ⑳ and remove .
(15) Warp around post to Arrow F to remove the Guide-Assy-D and remove the
photo-sensor .
(16) Warp around post to Arrow G to remove the Guide-Retard the Guide-Exit-Lower
and remove Photo-sensor .
45387101TH Rev.1
Arrow A
⑮
⑫
⑱
Arrow B
Arrow C
⑲
Arrow E
⑳
Arrow D
③
3. Component replacement
⑩
⑪
⑦
④
⑥
④
⑬
3
②
⑯
③
⑭
⑨
⑧
⑤
⑥
⑰
3-29 /
①