Toshiba e-STUDIO477S Service Manual page 69

3.2.33 Flatbed-Unit
(1) Remove the five screws (black/6mm) ① and remove the cover-Bottom ② .
(2) Remove the screw (silver) ③ and remove the platestopper(OP) ④ .
(3) Remove the two screws (black/12mm) ⑤ and remove thecover-OP ⑥
(4) Remove the screw(black) ⑦ and remove the Handle-scanner(S) ⑧ .
(5) Rotate the OP-panel-unit ⑨ 90 degrees.
(6) Remove the two screws(silver) ⑩ .
(7) Remove the screw(silver) ⑪ and remove the clamp-cable ⑫ and remove the OP-
panel-unit ⑨ .
⑦
⑧
⑥
⑤
⑩
Attention of assembly for direction of plate-stopper(OP)④
(for finisher model) (for without finisher model)
45387101TH Rev.1
⑩
⑪
⑫
⑨
④
③
②
①
①
①
3. Component replacement
3-31 /