3.2.6 Scanner unit
(1) Remove the ID unit. (Refer to 3.2.1)
(2) Remove the Cover-Side-R. (Refer to 3.2.5)
(3) Remove the Cover-Side (R-Top) ① .
(4) Remove the fifteen screws ② , and remove the Plate-Shield ③ .
(5) Disconnect the all connector of the scanner.
(6) Remove the three E rings ④ , and pull out the Shaft-Guide (Hinge) ⑤ .
(7) Remove the scanner ⑥ .
①
③
45387101TH Rev.1
④
⑥
⑤
④
②
×15
3.2.7 Stay-R
(1) Remove the Cover-Side-R. (Refer to 3.2.5)
(2) Remove the Scanner.(Refer to 3.2.6).
(3) Remove the soft-absorber ① and cover side(R-Inner) ② .
(4) Remove the seven screws ③ and remove the Plate-Stay-R ④ .
Note! When assemble the scanner, assemble the soft-absorber correct position and
close the scanner. (Frame and soft-absorber break may occur)
②
3. Component replacement
①
③
7
④
3-7 /