Maintaining The Machine; Replacing The Print Cartridge - Ricoh SP 200S Operating Instructions Manual

5. Maintaining the Machine

Replacing the Print Cartridge

• This machine does not monitor the remaining toner level, and no message will be displayed to
prompt the user to replace the print cartridge if the machine runs out of toner. Replace the print
cartridge if the printed image suddenly becomes pale or blurred.
• The print cartridge of this machine is equipped with a waste toner bottle. The print cartridge must be
replaced if the toner runs out or the waste toner bottle becomes full.
• Store print cartridges in a cool dark place.
• Actual printable numbers vary depending on image volume and density, number of pages printed
at a time, paper type and size, and environmental conditions such as temperature and humidity.
Toner quality degrades over time.
• For good print quality, the manufacturer recommends that you use genuine toner from the
manufacturer.
• The manufacturer shall not be responsible for any damage or expense that might result from the use
of parts other than genuine parts from the manufacturer with your office products.
1. Open the front cover, and then carefully lower it.
2. Carefully pull out the print cartridge horizontally, holding its center.
3. Take the new print cartridge out of the box, and then take it out of the plastic bag.
4. Hold the print cartridge and shake it from side to side five or six times.
Shake the print cartridge horizontally in the direction shown in this illustration. The first few printed
pages may appear blurred or smeared if the cartridge has not been shaken properly.
CTT045
27